4/14/2021 0 Comments Usb Gps Receiver Driver
RTKLIB does not support sensor device drivers, so it is necessary to force the driver installation process to revert to a driver that supports the COM port interface.To make things more confusing, there are actually three different drivers that will support the COM port interface.
Usb Gps Receiver Driver Installation ProcessYou can determine which driver you are using by opening the Windows Device Manager while the u-blox reciever is plugged into the computer. The receiver will either show up under Ports or under Sensors. If it shows up under Sensors then RTKLIB will not be able to see it. Here is an example of what it looks like when it shows up under Ports: If it shows up under Ports it may be listed in one of three different ways depending on which driver is installed. Usb Gps Receiver For Windows 10 When UsingThey are: USB Serial Device (COMx): This is the generic COM port Windows driver and is what u-blox recommends for Windows 10 when using the COM port interface. It will work fine with RTKLIB, but Windows has an annoying habit of automatically replacing it with the sensor driver, so I have recently stopped using this one. It has some limitations though, the primary one being that you can only run one of these devices on a computer at a time, so I dont recommend this one either. U-blox recommends this for older versions of Windows but I have started using this recently with Windows 10. So far I have found it works fine, and it does not automatically get replaced by Windows like the generic driver does. All three u-blox drivers are available for download from their Product Resources page. The older driver is listed as u-blox GNSS Standard Driver for Windows. U-blox has published a flowchart on their website to help users decide which driver to use and how to rollback to older drivers. Here is a copy of the document but it may be too small to read here and may be out of date by the time you read this so I suggest you click on this link to take you to the original document. To revert to the generic Windows driver with Windows 10, follow the instructions in the blue circle above. To revert to the older u-blox driver with Windows 10, you will want to first download that driver from the u-blox Product Resource page, then follow the instructions inside the blue circle. Usb Gps Receiver Code Features OnePost navigation Another Raspberry Pi RTKLIB project Demo5 code features One Comment VK5ATN September 21, 2018 at 6:29 pm Reply Thank you Thank you After days of intermittent anguish I discovered your advice, rolled back to the earlier driver suggested, and presto A working VK-172 device in windows 10 Fantastic Thank you again TN Leave a Reply Cancel reply Your email address will not be published. In order to post comments, please make sure JavaScript and Cookies are enabled, and reload the page. Click here for instructions on how to enable JavaScript in your browser. Getting started RTK Overview Selecting a GPS receiver Connecting the GPS receiver to a PC Configuring and testing the GPS receiver Getting started with RTKLIB Getting started with RTKNAVI RTKLIB: Customizing the input configuration file Adding a radio link Improving RTKLIB solution: (Receiver Dynamics and Error Ratio) Converting raw receiver data to standard text format using CONVBIN Base station data for RTKLIB Kinematic solution with RNX2RTKP Kinematic solution with RTKPOST Building RTKLIB 2.4.3 code with Visual C 2010 Plotting Observation Data: Cycle Slips Improving RTKLIB solution: (AR lock count and elevation mask) Installing u-blox USB drivers on Windows Exploring moving-base solutions Projects Pi Zero Based GPS data logger Another Raspberry Pi RTKLIB project NEO-M8T GNSS FeatherWing A SiteOrigin Theme.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |